Haier ESD200 Manual Del Usuario página 31

ESD200-MANUAL 1/10/03
English
Dishwasher will not fill:
• Check the water supply.
Make sure that the water supply is in "ON" position.
• Check water pressure.
Make sure the water pressure is at the proper level. (Between 20 – 120 PSI)
Water found under the filter:
• A small amount of water found under the filter area after completion of the cycle
is normal.
Detergent found in the compartment:
• Do not load items too close to the detergent compartment. This may block the
automatic release of the detergent.
• Do not use old or caked/dried detergent in the compartment because it will not
dissolve properly and will leave a sandy residue on dishware.
Dishwasher is running for too long:
• The temperature of incoming water is below 120˚F. Raising your water heater
setting will help to shorten the time of operation.
• Call the Haier Customer Satisfaction Center if this does not resolve the problem.
Beeping Sound and Flashing Light(s):
• The dishwasher door is not closed properly.
After pressing the "START/PAUSE" button to start the wash process and if the
door is not closed properly or the door is opened in the middle of the wash
process, you will notice the following,
- The 1st light from the left of "Wash Programs Indicator Lights" will flash.
- The machine will continue to beep every few seconds.
• Close the door properly. The machine will stop beeping. The selected wash
program light will flash and the wash process begins automatically.
• If the dishwasher malfunctions in the middle of the wash operation, the "Wash
Programs Indicator Lights" will flash and the machine will beep.
29
11:29 AM Page 31