Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
General Safety Information
Safety is a combination of common sense, staying alert
and understanding how your utility pump works.
Safety Signal Words
information is NOT followed someone WILL be
seriously injured or killed.
information is NOT followed someone COULD be
seriously injured or killed.
information is NOT followed someone MAY be injured.
information, that if NOT followed, MAY cause damage
to the equipment or flooding.
instructions. Failure to follow all instructions listed
below COULD result in fatal electric shock, fire,
property damage, and/or serious personal injury.
California Proposition 65
cord MAY contain chemicals known to the State of
California to cause cancer and birth defects or other
reproductive harm. Wash hands after handling.
SAVE THESE INSTRUCTIONS!
Unpacking
Inspect this unit before it is used. Occasionally,
products are damaged during shipment. If the pump
or components are damaged call our customer service
department at 1-877-9RIDGID.
Work Area
• Do NOT operate pump in explosive atmospheres,
such as in the presence of flammable liquids,
gases, or dust. Pump motors create sparks which
WILL ignite the dust or fumes.
• Keep by-standers, children, and visitors away
while operating pump. Distractions WILL result in
mistakes.
Model TP-500K – Operating Instructions and Parts Manual
means if the safety
means if the safety
means if the safety
indicates important
Read and understand all
This product or its power
Ridge Tool Company
Electrical Safety
• Do NOT submerge motor or allow motor
to be exposed to water. Personal injury and/or
death WILL result.
• This pump must be plugged into a properly
installed and a grounded GCFI outlet in
accordance with all applicable codes and
ordinances. NEVER remove the grounding prong
or modify the plug in any way. Do NOT use any
adapter plugs. Check with a qualified electrician
if you are NOT sure the outlet is grounded. If the
pump should electrically malfunction or break down,
grounding provides a low resistance path to carry
electricity away from the user.
• Electrical wiring must be performed by a
qualified electrician. Improper wiring COULD
result in fatal electrical shock.
• Do NOT abuse cord. NEVER use the cord to
carry the pump or pull the plug from an outlet.
Keep cord away from heat, oil, sharp edges,
or moving parts.
immediately. Damaged cords increase the risk of
electrical shock.
• Before using, test the Ground Fault Circuit
Interrupter (GFCI) to insure it is operating
correctly. A GFCI reduces the risk of electrical
shock.
• Do NOT use an extension cord. This increases
the risk of electrical shock. If necessary, install a
properly grounded outlet closer to the pump.
Grounding Blade
Power Cord
Figure 1
Replace damaged cords
Grounded GFCI
Outlet
TEST
RESET
1
Publicidad
Tabla de contenido
