Craftsman CMKGAAV45099000 Manual De Instrucciones página 12

ENGLISH
STEP 6
Aligning Wheel Pads to Fit Mower
• Position the jack in front of the mower.
• Remove Push Pins and adjust the wheel pad to align with
the mower's front tires.
• Replace the Push Pins to lock the Wheel Pad Lift Arms to
the Lift Arm.
WARNING: Wheel Pad Lift Arms must be equal distance from the
Lift Arm to maintain proper balance.
STEP 7
(optional – if not applicable, skip to Step 8)
In some cases, the mower deck or anti-scalping wheels will hit the Lift Arm while
the mower is being raised. This is often the case if part of the deck (including the
anti-scalping wheels) protrudes past the center line of the front wheels of the
mower. If this happens:
• Rotate the front tires 180° so that they are in the reverse position.
• Slide the lift as close to the wheels as possible.
NOTE: Reference Step 6 for Aligning Wheel Pads to fit ZTR mower.
Using the Lift (Steps 8 - 15)
STEP 8
Move mower onto jack
WARNING: The jack must be used on a solid level surface.
• Drive or roll the mower onto the Wheel Pads.
WARNING: Stop engine and remove the key.
NOTE: Wheel Pads accommodate wheel sizes from
10" – 17" (25cm – 43cm).
WARNING: Not for use with tires over 17"
(43cm) in size.
12
Forward
Wheel
Position
Reverse
Wheel
Position