Craftsman CMKGAAV45099000 Manual De Instrucciones página 15

STEP 14
Removing the Mower from the lift
• Remove the Safety Straps from front mower tires.
• Drive or roll the mower off of the Wheel Pads.
STEP 15
Raising the lift with a power drill
(optional – power drill not included)
The lift can be raised or lowered by using a variable speed corded
drill (7 amp minimum) or variable speed cordless drill (18V mini-
mum). The drill will require a 3/8" square driver (not included).
• Remove Crank Handle by taking off the Nylon Lock Nut and
Spring using 13mm wrench.
After Crank Handle removal, re-attach Spring and Nylon Lock
Nut to Crank Handle to prevent loss.
• Firmly insert the 3/8" square driver in the Square Receiver.
Rotate the drill forward (clockwise) to raise the Lift Arm and
rotate the drill in reverse (counterclockwise) to lower the Lift
Arm.
NOTE: Carrier Locking Handle must be manually pulled out when
lowering until it clears the bottom Tower Hole.
WARNING: Operator must have a firm grip on the drill before raising or
lowering the Lift Arm.
NOTE: Crank Handle must be removed in order to use the drill attachment.
Follow all other operating instructions while using the drill
attachment. Replace the Crank Handle as necessary for future use.
NOTE: When re-assembling handle, take care not to over-tighten the Nylon Lock Nut
against the spring. There should be enough free space for the handle to be pushed in
to move from storage position to operating position.
NOTE: When re-assembling the handle, a "popping" sound may
occur due to the re-engagement of the clutch system.
ENGLISH
Make sure drill is fully
charged and set at
highest torque.
3/8"
Square
Square
Receiver
Driver
Square Driver not included
Before using a drill,
remove the Crank Handle
Crank
Handle
Nylock
Locking
Spring
Nut
15