Installing The Washer; Step 1: Position Washer Near Installation Area; Important; Step 2: Connect Water Inlet Hoses - Alliance Laundry Systems H370I Guia De Instalacion

Installing the Washer

NOTE: If the washer is delivered on a cold day
(below freezing), or is stored in an unheated room
or area during the cold months, do not attempt to
operate it until the washer has had a chance to
warm up.
Step 1: Position Washer Near Installation
Area
IMPORTANT: Install dryer before washer. This
allows room for attaching exhaust duct.
Move washer as close to the desired area of
installation as possible.
Figure 2
801561
D772I
D772I
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Step 2: Connect Water Inlet Hoses

NOTE: Refer to section on Water Supply
Requirements before connecting water inlet hoses.
Turn on the water supply faucets and flush the lines for
approximately two minutes to remove any foreign
materials that could clog the screens in the water
mixing valve.
NOTE: When installing in newly constructed or
renovated building, it is very important to flush the
lines since build-up may have occurred during
construction.
Remove the four plain rubber washers from accessories
bag, and install them according to Figure 3.
IMPORTANT: Thread hose couplings onto valve
connections finger-tight, then approximately
1/4 turn with pliers. DO NOT cross thread or
overtighten couplings.
Turn water on and check for leaks. If leaks are found,
retighten the hose couplings. Continue tightening and
rechecking until no leaks are found.
1 Rubber Washer (Plain)
2 Inlet Hose
Figure 3
Installation
1
2
H091I
H091I
7