V2 Blitz Serie Manual De Instalación página 12

ACTUATOR FASTENING
As soon as the measures selected from the table, which is on the
previous page, have been marked on piers, proceed with the
following operations, considering figure 1 as a reference:
• Fasten the anchor plate
proper screws and blocks.
• Enter the ratiomotor into the anchor plate and fasten it by
means of screws , washers
shaft must be turned downwards).
• Assembly the articulated arm and the relevant bracket as
shown in the figure.
• Fit the articulated arm into the shaft and fasten the screw
• Release the ratiomotor (see paragraph EMERGENCY LOCK
RELEASE).
• Mark the front bracket fastening points on the door
according to the previous established levels.
• Separate the front bracket F from the articulated arm.
• Fasten the bracket on the door by means of screws or
directly weld it in case the material it is made of allows it.
• Link the clamp to the pivoted arm.
• Make several manual attempts in order to open and close
the doors by checking that no unwanted friction occurs.
• Proceed with ELECTRICAL CONNECTIONS and ADJUSTMENT
OF STOP ENDS.
• Insert the cap , the plug
and fix the two screws.
WARNING: For the left actuator install the motor as
shown in fig.2 and repeat the above operations.
Fig. 1
Fig. 2
to the pier by making use of
and nuts supplied (the
, the unclamping handle
.
10