Tabla de contenido
Publicidad
Detergent / Storage
•
Use detergents designed for power washers. We offer four (4) power washer detergents,
Auto, Motorcycle, Boat and Universal. These can be purchased online at our website www.
arblueclean.com. Hardware stores or home centers also have power washer detergents for
different cleaning projects. The cleaning solution should be the consistency of water in order to
prevent clogging your detergent bottle and nozzle.
•
The cleaning power of the detergents is enhanced when applied with low pressure; and
time is allowed to break down the dirt and grime. The combination of low pressure and
chemical action is very effective and can be better than scrubbing if applied properly.
Always spray detergent on a dry surface, do not pre-soak area. Wetting the surface first
dilutes the detergent and reduces its cleaning ability. Do not allow detergent to dry on
surface. On vertical surfaces being cleaned, apply detergent to lower surfaces and work
your way up to prevent detergent from causing streaks in the dirt and grime. Rinse
detergent by pressure washing from bottom up for same reason.
•
If a stain is particularly tough, it may be necessary to reapply the detergent and use a bristled
brush to scrub the stain. Subsequent power washing after brushing should successfully complete
your cleaning job.
S
torage
•
Remove lance from the gun and place in the accessory holder. Place the gun in the accessory
holder one the side. Lances are placed into any of the slots in the back of the unit. Make sure
to discard any remaining detergent from the bottle. Flush the bottle and nozzle head with fresh
water to prevent clogging.
•
When your pressure washing session has been completed, turn off the power switch located on
the front of the power washer. Unplug the power cord from the outlet. Turn off the water supply.
Pull the trigger on the spray gun 2-3 times to drain out the excess water and to release any
remaining water pressure. Disconnect the garden hose adapter from the water inlet. Do not allow
the power washer to run with no water flowing through it.
•
Remove detergent bottle and clean completely. Residual chemical will stick to the container and
can cause the detergent injector to clog and not function properly.
•
Remove high pressure hose from spray gun and unscrew the other end of the high pressure hose
from the power washer.
•
Hook the power cord around the L-shaped tab on the right side of the machine when facing it.
•
The pressure hose is stored on the hose hook located on the back of the handle.
•
DO NOT store the power washer where it is exposed to freezing temperatures unless
you use Pump Saver. It is recommended that you use Pump Saver for storing in freezing
temperatures. Freezing will damage the pump unless Pump Saver is added to the power washer.
If not using or if storing your power washer for more than one month, run Pump Saver through it.
See the section on Pump Saver for more information.
en 16
Publicidad
Tabla de contenido
