Before You Begin Setup; Network Information; Step 1: Connect Your Hd Source; Slingbox - Slingbox PRO-HD Guia Del Usuario

BEFORE YOU BEGIN SETUP :

To make the setup process easier, write down the type, brand and model of the
A/V sources, along with information about your home network. This will come in
handy when you confi gure the software later on.
HD - High Defi nition Source
SOURCE TYPE :
BRAND :
MODEL :
SD - Standard Defi nition Source
SOURCE TYPE :
BRAND :
MODEL :

Network Information

ROUTER BRAND AND MODEL :
MODEM BRAND AND MODEL :
INTERNET SERVICE PROVIDER : (ISP)
TYPE OF INTERNET SERVICE : [EX : DSL]
4
STEP 1 : CONNECT YOUR HD SOURCE
VIDEO :
If you have a high-defi nition device, you can connect it to
your Slingbox with the included component video cables.
Component video cables have a set of green, blue and red
connectors. Connect these cables to the component sockets
labelled IN on your Slingbox PRO-HD. These sockets are in the
top row on the back of your Slingbox. Connect the other ends
of the component cables to the output component sockets on
your HD video source.
If your HD A/V source is already connected to your TV with
component cables, disconnect them from the TV and then
re-connect these cables to the component IN sockets on
your Slingbox. Use the matching cable set included with your
Slingbox to connect to the component OUT sockets on the
back of your Slingbox, and then to the IN sockets on your TV.
NOTE: THE SLINGBOX PRO-HD SUPPORTS RESOLUTIONS UP
TO 1080i. IF YOUR A/V SOURCE OUTPUTS 1080p, YOU MUST
SET IT TO 1080i . THE SLINGBOX WILL NOT WORK WITH 1080p.
5