Step 4: Attach The Remote Control Ir Cable - Slingbox PRO-HD Guia Del Usuario

STEP 3 : CONNECT YOUR AERIAL CABLE
Aerial cables carry both video and sound. They are used to
receive Freeview TV stations. Connect your aerial cable to the
socket labelled COAX IN on your Slingbox PRO-HD.
If your aerial A/V source is already connected to your TV with
an aerial cable, disconnect it from the TV and then re-connect
this cable to the COAX IN socket on your Slingbox. Use the
matching cable included with your Slingbox to connect to the
COAX OUT socket on the back of your Slingbox, and then to the
IN socket your TV.
10
STEP 4 : ATTACH REMOTE CONTROL IR CABLE
Connect the remote control IR cable to the IR socket on the
Slingbox. Next, place a remote control IR cable head on the top
or bottom of your A/V device so it points at its IR sensor.
Make sure that the head of the remote control
IR cable extends out far enough over the
front of your A/V device to send a signal to it.
You may want to affi x the remote control IR
cables using the adhesive pads after you've
determined their correct positions.
TIP : The IR sensor is on the front of your A/V device. Some sensors are behind a
dark, reddish plastic window. Others may be hidden behind the plastic on the front
of the device. If you don't see the sensor, shine a torch on the front of the device
and look for a small bulb similar to the one on the end of the remote
control IR cable. To control more than one device, you can use the
multi-head remote control IR cable that came with your Slingbox
PRO-HD. You can use one or more IR heads per device as needed.
IR Sensor side view
positioned above or
below the A/V device
11