Install The Blower - Beat WP28M Serie Manual De Instalación

13. INSTALL THE BLOWER

Refer to instructions included with blower.
Once the blower is installed, plug the power supply to the 3-prong male connector (A)
and the blower unit into the 2-prong female receptacle (B) inside the hood.
Do not plug the two cords into each other.
14. INSTALL THE CALIBRATION BUTTON BRACKET IN THE HOOD
(iQ6 AND iQ12 INTERIOR BLOWERS ONLY)
Both iQ6 and iQ12 blowers are equipped with a calibration button already mounted
to its own bracket. Install this bracket in the hood, using 2 screws provided with
iQ6 or iQ12 interior blower.
See additional details in the iQ6 and iQ12 blower instructions included with the
blowers.
15. REINSTALL BAFFLE FILTERS
Remove protective plastic film covering hybrid baffle filters before reinstalling them.
It is recommended to install side filters first and finish with center one(s).
 Insert the end with filter spring clip of hybrid baffle filter into the upper channel
of the hood.
 Raise the other end toward the inside of hood and insert in the grease drip rail
of the hood.
Replacement filters are available from your dealer. See label inside hood for size
and part number.
(INTERIOR OR EXTERIOR BLOWER)
WARNING
!
HE0003
HD545
CAUTION
HD0546
10
A
B