Install The Hood - Beat WP28M Serie Manual De Instalación

7. INSTALL THE HOOD

Rest the back cavity of the hood on the wood mounting strip.
CAUTION
Hold the hood until it is completely secured to the wood mounting strip.
T ( )
OP OF HOOD INSIDE VIEW
M
OUNTING SCREW LOCATIONS
Secure the hood to wood mounting strip with 4 screws no. 8 x 3/4" (for
30" and 36" width hoods) or 6 screws (for 42" width and wider hoods)
provided at locations shown. Drill two 3/16'' size holes into the drywall
for wall anchors through the existing holes in the inside hood back in
the locations shown. Then, install both wall anchors and attach the hood
B ( )
with the remaining no. 8 x 3/4" screws and both washers provided. ACK OF HOOD INSIDE VIEW
W
ALL ANCHOR LOCATIONS
HD0047
8. SELECT BLOWER OPTION
(EXTERIOR OR INTERIOR)
INTERIOR BLOWER: Follow all subsequent steps of this manual.
EXTERIOR BLOWER: Refer to instructions packed with exterior blower and follow steps 10 to 13, then 15 and up of the present manual.
9. ATTACH 8" ROUND ADAPTER AND DAMPER TO ROUGH-IN PLATE
(iQ6, P3 OR P6 INTERIOR BLOWER)
Attach 8" round adapter and damper to iQ6, P3 or P6 blower rough-in plate.
Use metal duct tape to make all joints secure and air-tight.
HO0196
8