Care • Operation • Service
READ ALL INSTRUCTIONS BEFORE USING THE HEATER
Operation – 7 step set-up for SunTwin
1) Unpackage heater: cut open tape area, fold back flaps and gently turn
entire box upside down. Lift box from styrofoam packing. Remove
styrofoam, turn upright. We recommend keeping the packaging for
off-season storage and any transporting needs.
2) Find a level and unobstructed location to place the unpackaged heater.
3) Plug the power cord directly into an unused grounded 110 volt 15 amp
or higher circuit receptacle.
4) Insert 2 AAA batteries into the battery compartment on the remote
control.
5) Push the "Power" button located on the front of the heater or the
remote control to turn the heater on. Adjust the "temp up" and "temp
down" buttons until the desired temperature is reached. Once the
desired temperature is reached the heater will cycle on and off to
maintain the room temperature.
6) To turn the heater off, press the "Power" button, the fan will continue
to run until all of the heat has been expelled and will then turn off.
7) The heater is equipped with a temperature limiting control contained
inside the unit. If the heater stops working, shut the power off and let the
unit cool down. Turn the power back on and resume use. If the unit
continues to shut down or the unit does not reset itself, please contact us
for service.
Cabinet Care – Wipe clean with a soft damp cloth.
Heater Storage – When the heater is not going to be used for an
extended period of time, please do the following:
1) Unplug Heater.
2) Wind up electrical cord so as to keep it off of the ground.
3) Cover the heater to prevent dust from accumulating on filter
or internally.
4) Store the heater in a dry, low dust environment.
Service – To replace a heating element or for other repairs or service,
please contact the dealer you purchased your heater from or find an
authorized service center in your area by visiting us at
www.edenpureservice.com, or call us toll-free at 1-866-786-8946.
SAVE THESE INSTRUCTIONS
1500 Elite
™
4