REGULATOR AND LP CYLINDER CONNECTIONS
CAUTION
The pressure regulator and hose assembly provided
with this gas grill must be used. This regulator is set
for an outlet pressure of 11 inches water column.
Replacement pressure regulators and hose assemblies
must be those specified in the parts list.
Your regulator is equipped with a Q.C.C. Type 1 quick
connect system. It will not allow gas to flow until a
positive seal has been made. It has a flow-limiting
device that will restrict the flow of gas to 10 cubic feet
per hour (0.28 cubic meters per hour).
TO PLACE THE CYLINDER INTO THE GRILL
CABINET
1.
Place the LP tank cylinder in the cabinet Base.
front of the tank valve should face out from the
enclosure.
2.
Wrap the tank support ring around the tank and
latch over its hook to secure the tank.
TO CONNECT THE CYLINDER TO THE REGULATOR
AND HOSE
1. Place the cylinder into the cabinet following the
information in the assembly instructions.
2. Be sure the LP cylinder is "OFF" by turning the
hand wheel clockwise until it stops.
3. Be sure the burner controls are turned to the "OFF"
position.
4. Remove the safety cap from the cylinder valve.
5. Center the nipple of the regulator into the cylinder.
6. Turn the black nut clockwise until it stops.
Hand Tighten Only. Do Not Use A Wrench.
The regulator must enter the
cylinder valve in a straight line.
Q.C.C.1 Type 1 Connector
Keep the gas cylinder in the upright position at all
times.
•
Do not connect this grill to any unregulated
sources of propane.
•
Before each use, check the gas hose for excessive
abrasion or wear, or cuts. Replace a hose
assembly showing those signs with the
hose assembly specified in the parts list before
using the grill. Inspect the hose assembly by
following it from the LP tank connection to the
gas manifold assembly.
•
Always perform the Leak Test listed below
before using your grill for the first time, if the
cylinder has been changed, any gas
components have been changed, the regulator
flow-limiting device has been activated, or
after a long period of non-use.
Do not attempt to connect this grill to the LP
system of a motor home or trailer.
20
Center this nipple of the
regulator into the cylinder valve.