Bycool SCANIA COMPACT 3.0 Instrucciones De Montaje página 18

COMPACT 3.0
EN
15
Once these operations have been carried out,
take down the console in order to secure the
supports by tightening the nuts (A) until the
original edgeband is tight against the base of
the unit, then tighten nuts (B) and (C) (see
diagram).
15
16
Important:
In order to prevent water from dripping,
ensure the original edgeband is tight against
the base of the unit, as shown in the diagram.
17
Place console with (4) originale screws, put
round 8 plastic trims on them.
16
Check compression
thickness using a
tape measure in the
four corners.
18
Air conditioning for vehicles
B
A
Original edgeband
3÷6 mm.
Tighten nuts A until original edgeband
torque is between 3 and 6 mm.
C
15
16
Compact base
B
C
A
M8 selfblocking
17