Publicidad
Step 14
Separate the EXTENSION SLIDES (Y and BB) from the
å
EXTENSION RAILS (X and AA) as shown in the upper
diagram below. Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (X and AA) to the RIGHT
å
END (A) and UPRIGHTS (C and D2). Use twelve GOLD
5/16" FLAT HEAD SCREWS (XX).
NOTE: For each EXTENSION RAIL, turn a SCREW into the
å
hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL out to fi nd the other
hole that lines up with the hole in the END. Turn a SCREW
into this hole.
GOLD 5/16" FLAT HEAD SCREW
(12 used in this step)
AA
Open end
Finished edge
www.sauder.com/services
Push the black lever in and pull the SLIDE from the RAIL.
XX
AA
A
C
X
Drawers on right side of the desk
Open end
X
AA
D2
Use the exact
holes shown.
404972
Open end
Finished edge
X
This UPRIGHT will
not be used until the
Return is assembled.
Page 19
Publicidad
