Publicidad
Idiomas disponibles
Idiomas disponibles
HYSC00F0P0
PSOPZKEY00
PSOPZKEYA0
HYKA000000
NTC010HP02
NTC030HP02
NTC050HP02
NTC010HP0R
NTC016HP0R
NTC030HP0R
NTC050HP0R
3. INITIAL CONFIGURATION PROCEDURE
The MasterAria is configured mainly from the "acqua" remote terminal.
Further settings are made using the dipswitches on the board inside the panel: HYCT000000.
Below are the various phases required to complete the configuration of MasterAria.
3.1
Dipswitch settings
The dipswitches on the MasterAria main board are used to select a number of predefined settings concerning the type of AHU and installation. This
configuration must then be completed by the settings made on the "acqua" terminal. Set the dipswitches as follows:
Dipswitch
Setting
1
ON=Enable heat/cool function enabled (probe B2 on coil). Probe B3 enabled only
when DIP1=ON and DIP4= ON;
OFF= Enable heat/cool function disabled
2
ON = Enable digital input 2 for heat/cool changeover
OFF= Disable digital input 2 for heat/cool changeover
3
ON = Remote off active
OFF= Remote off active not active
4
ON = AHU with 2 water coils
OFF= AHU with 1 water coil
5
ON = Electric heater fitted
OFF= Electric heater not fitted
6
ON = Control probe is the probe on the acqua terminal (BT)
OFF= Control probe selected between B1, B2 or B3 (correspondingly P15, P16 or P17
must be =5)
3.1.1
Accessing the configuration menu
To access the parameter configuration menu, with the unit off press the
The password entered using the
Code +050001260 – Rel. 2.0 – 22/01/08
RS485 serial board
Programming key with battery
Programming key with power supply
key adapter
Programming
NTC HP , JST connector , L= 1 m single pack
NTC HP, JST connector, L= 3 m single pack
NTC HP, JST connector, L= 5 m single pack
NTC HP, JST connector, L= 1 m pack of 50pz.
NTC HP, JST connector, L= 1,6 m pack of 50pz.
NTC HP, JST connector, L= 3 m pack of 50pz.
NTC HP, JST connector, L= 5 m pack of 50pz.
buttons is 22.
Note
for the implementation see parameter P56 :
0
1
Functions inhibited : ON/OFF timer, Sleep.
Automatic operation forced on
and
buttons.
16
MasterAria
N.C.=Heat, N.O.=Cool
N.C.= Cool, N.O.=Heat
Fig. 3.a
Publicidad
