Pioneer S-HV600B Manual De Instrucciones página 5

S-SLW500
Installing the subwoofer
The subwoofer can be mounted in either vertical or horizontal ori-
entation. The factory default is horizontal orientation.
For vertical orientation installation
1 The feet are attached with Phillips screws; use a Phillips
screwdriver to remove them.
2 Apply the accessory seals to the place the feet were
located to hide the screw holes.
3 Apply the non-skid pads to the four corners of the surface
where the subwoofer is to be mounted. Note that the non-
skid pads may not be fully effective on all surfaces, so do not
install in slippery locations.
Step 1
Feet
Step 2
Seals
Step 3
Non-skid pads
• Do not attempt to perform these procedures while tilting the
unit at an angle. Lay the unit on its side on soft cloth or other
material that will not scar the unit.
Installation
Mounting location
Installation example: For both S-HV600B and S-
SLW500
Installation example: For both S-HV500-LR and S-
SLW500
S-HV600B
• Sounds played through speaker systems are easily affected in
subtle ways by the conditions in the listening space.
• This speaker system does not feature a magnetically shielded
design. As a result, color distortion may occur if the speaker is
placed near a conventional CRT television. In this event, move
the speaker farther away from the television. In addition,
devices easily affected by magnetism (magnetic media cards,
wrist-watches, video tapes, etc.) should not be placed near
this speaker.
• If the room has a lot of reverberation, we recommend hanging
heavy fabric on the walls, and/or putting a carpet on the floor
to damp the sound. For best results, cover walls completely.
5
En