Starting Cleaning Operations; Manual Direction Setup - Dolphin Wave Instrucciones De Uso

14. Line Spacing- used only when Lines to Right / Left scanning path is
used, in order to optimize scanning. Choose Fine / Medium / Coarse to
set the distance between lines.
15. Reset Pool Profile- Allows to delete all current pool profile parameters.
(Pool Length, Cycle Time, Navigation Mode, Delay time...)
During parameter setting operations:
• Press
Back
•
Press HOME on the console, to return to the Wave screen

Starting Cleaning Operations

Once all the customized settings have been configured, you can proceed to a
cleaning session:
1. Prepare the Dolphin Wave for operation and immersion into the pool.
2. Proceed as in Everyday Operation, page 5.
If a Delay Time has been set (see Configuring the Dolphin Wave, above), the
countdown commences and the time remaining before automatic cleaning
starts is displayed on the screen.
If no delay time is specified, the robot commences cleaning immediately.
Once cleaning operations have started, the MMI screen displays the
countdown time as in Figure 5, above.
To override the delay time and commence cleaning immediately, press
Start. The robot starts working immediately.

Manual Direction Setup

After the cleaning cycle has started, you might find it necessary to set the
robot's direction more precisely.
This can be performed in 2 ways:
a) Using Direction Setup – from pool profile. Press start and go through
similar procedure as described in Starting the First Cleaning Session, line No.
5, page 4.
b) Using the Direction Setup procedure while the robot is in the pool, as
described below.
Direction Setup:
1. From the Countdown screen press Stop. (If the robot is during cleaning
cycle)
If the screensaver is displayed, press POOL and then HOME to unlock
the MMI.
2. Navigate to the Pool Profile screen and select Direction Setup and
then Fine Tuning.
3. Press Start. The robot starts moving along the width of the pool.
to return to the previous screen
13