Everyday Operation - Dolphin Wave Instrucciones De Uso

Everyday Operation

After you have set up the Dolphin Wave and configured it for the first time,
the device is set for everyday operation. When performing your next cleaning
session, proceed as follows:
1. Position the caddy about 0.5–1.0 meter from the pool edge with its
front sloping edge facing the swimming pool and the floating cable
pointing in the direction of the Dolphin Wave power supply unit.
2. Press Pool on the MMI. The robot starts moving towards the pool and
enters the swimming pool positioning itself on the pool floor.
3. Wait for the Wave screen to display on the MMI.
4. To start the robot, press Start on the MMI. The robot starts its cleaning
cycle and the Countdown screen displays:
lock
To avoid unauthorized changes to the MMI settings you can lock the
MMi's keyboard:
From the countdown screen, press Lock (Figure 5).
To unlock the keyboard, press POOL and then HOME in that order.
At the end of the cleaning session, the robot stops automatically.
Removing the Robot from the Swimming Pool:
1. Press HOME.
The robot starts moving in the direction of the floating cable.
2. Holding the floating cable, gently pull the robot upwards and towards
the caddy. As it reaches the side of the pool, pull the cable gently until
the floating cable handle emerges. Grasp the handle, tilting the robot
slightly allowing water to drain, place by the pool side, or guide it onto
the caddy. The robot shuts down automatically.
3hr - cycle
Default cleaning
02:59:59
Figure 5: Countdown screen
5
hh:mm:ss
stop