Publicidad
Step 13
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the mounting screw
å
is against the stops as shown in the right diagram. If it isn't, loosen
the mounting screw to slide it against the stops. Then tighten the
mounting screw. Door adjustments will be made in the next step.
Fasten a DOOR (H) to the LEFT HINGE MOLDING (O). Use the
å
screws in the HINGES. You should start each SCREW a few turns
before completely tightening any of them.
Fasten a KNOB (KK) to the DOOR (H). Use a BLACK 1-1/8"
å
MACHINE SCREW (QQ).
Peel a FELT DISC from the FELT DISC CARD (LL) and stick it on the
å
DOOR (H) where it comes in contact with the UPRIGHT (D).
Repeat this step for the other DOOR (H).
å
KK
BLACK 1-1/8" MACHINE SCREW
(2 used for the KNOBS)
www.sauder.com/services
O
H
LL
QQ
D
411865
Stop
Mounting
screw
Hinge
Page 17
Publicidad
