Publicidad
Step 4
Fasten the UPPER HALF DISKS (AA) to the UPPER PLINTHS (Y). Use two
å
BROWN 1" FLAT HEAD SCREWS (RR).
Fasten the UPPER PLINTHS (Y) to the END MOLDINGS (Q and R). Use
å
two BLACK 1-1/4" FLAT HEAD SCREWS (PP).
Fasten the SIDE MOLDINGS (X) to the END MOLDINGS (Q and R). Use
å
four BLACK 1-1/4" FLAT HEAD SCREWS (PP).
NOTE: The SIDE MOLDINGS do not have holes in them. Turn a screw
å
through the END MOLDINGS and into the groove of the SIDE MOLDING.
Do not overtighten.
The larger hole should be facing up.
AA
Y
PP
BLACK 1-1/4" FLAT HEAD SCREW
(6 used in this step)
Page 8
AA
BROWN 1" FLAT HEAD SCREW
Y
X
R
411865
RR
(2 used for the HALF DISKS)
Q
X
AA
Y
AA
Y
These edges should be even.
These edges should be even.
www.sauder.com/services
Publicidad
