System Connection - Beeper RWEC110X-N Instalación Y Uso

4. SYSTEM CONNEXION
CAMERA POSITION
• Connect the 15 m. extension between the screen & the camera
• Connect the beam (6 wires) on the screen
• Connect the BLACK wire to the original mass
• Connect the RED wire to the ignition +12V (15)
• Connect the GREEN wire to the +12V reverse light N
Camera
Optional camera connection
(not supplied)
4 pins screw connection
Camera
+ 12V Reversing light • GREEN: Switching the camera at the passage of the reverse
Loop for the selection of
templates viewing distances
15 meters extension
Ref : RX-45/15
+ 12V after ignition • RED: Automatic activation display
Ground • BLACK: Alimentation (-)
! The red wire should not be connected on
+12V permanent. Consumption in standby is of
130 mA to 230 mA. If the kit works 24/7, that will
cause a premature wear of the product, which will
not be taken under warranty.
15 meters
extension
4 pins screw
connection
4 pins screw
connection
19
7" Screen monitor
AV2 Input CAMERA
Connecting the camera included in the pack
AV1 input VIDEO IN1
AV1
Optional camera (not supplied)
Cannon connector