Editing Locomotive Settings | Locomotive Card - marklin Central Station 3 Manual Del Usario

Editing Locomotive Settings | Locomotive Card

Changing to the Editing Mode
You activate the editing mode with a tap of your finger on the
tool symbol and then on „Edit Locos" (left image). You will rec-
ognize it by the green check mark appearing at the foot of the
tool symbol (image below): All of the locomotives now appear
with a dashed frame and they can be deleted by means of a
brief touch on the „X".
Now you can edit the
settings for the locomo-
tives: To do this tap on
the desired locomotive
(right image) and the
locomotive settings will
open (image below).
Tab „Info": Changing Main Data
Reading the Address on the Locomotive Decoder
You are now in the opened tab
„Info" for the locomotive set-
tings. Even with mfx locomotives,
you can change the name and
the maximum speed shown on
the locomotive controller – if
desired.
www.ajckids.com
On the upper edge of the „Info" tab for the
locomotive settings, you will find the option
„Read" for MM and DCC locomotives: Tap
on it and the CS3 takes over the address set
in the locomotive decoder.
Tip: A new locomotive must be added before
this (see Page 11).
„Setting Up" the Tab: Changing Important Settings and Functions
You get to the locomotive settings by first activating the editing mode in the locomotive list
and selecting the locomotive to be edited (see the section „Changing to the Editing Mode" on
the left side of this page. Then tap on the tab „Set Up".
Setting up the
functions.
Setting
operation mode.
Transferring
locomotive
data to a loco-
motive card.
Resetting locomotive to
Important: Altered data are immediately stored in the locomotive decoder. MM and DCC
locomotives must be on the programming track to be edited.
Special Case for a Locomotive Card: Reading and Storing Locomotive Data
You can take locomotives into the locomotive list from existing cards
or you can rewrite a locomotive card.
Reading: Insert the locomotive card into the card reader as shown.
The data are taken into the locomotive list and you can run the
locomotive immediately. Important: Make sure that the chip on the
card is facing down.
Writing: Insert the locomotive card into the card reader as shown.
Tap on the symbol „Locomotive card" in the tab „Set Up" in the
locomotive settings: The CS3 will write the locomotive data on the
locomotive card.
Determining
acceleration and
braking delay.
Setting minimum
and maximum
speed.
Setting volume.
factory default.
12