Disposal Information - Bahco BBCE12-15S Manual Del Propietário

16. DISPOSAL INFORMATION

Do not dispose of this product with other household waste. To prevent possible
harm to the environment or human health from uncontrolled waste disposal, and
to promote the sustainable reuse of material resources, recycle it responsibly. To
discard your used device, please use the return and collection systems or contact
the retailer where the product was purchased, for environmentally safe recycling.
17. TROUBLESHOOTING
PROBLEM
Battery connectors do
not spark when touched
together.
The charger will not turn on
when properly connected.
I cannot select a language
on the display.
Green LED is lit and the
display shows ANALYSING
BATTERY.
Green LED is flashing and
the display shows CHARGE
ABORTED - BAD BATTERY.
The display shows
CONNECT CLAMPS.
The display shows
EXTERNAL BATTERY
VOLTAGE TOO HIGH.
18. SPECIFICATIONS
Input ....................................................................................... 230 V AC~50 Hz, 2.5 A/1.8A
Output ......................................................................................... 12 V
Ingress Protection rating ..............................................................................................IP20
POSSIBLE CAUSE
The charger is equipped with an
auto-start feature. It will not supply
current to the battery connectors
until a battery is properly connected.
The connectors will not spark if
touched together.
AC outlet is dead.
Poor electrical connection.
Press the button for 5 seconds to
select a language:
(EN→ DE→ FR→ NL→ ES).
The charger needs to check the
condition of the battery.
The battery is too large for the
charger.
The battery voltage is still below
10 V after two hours of charging.
The clamps are not making a good
connection.
The fuse is bad.
The external battery voltage is more
than the unit with power supply
mode.
• •
11
SOLUTION
No problem; this is a normal
condition.
Check for an open fuse or circuit
breaker supplying the AC outlet.
Check the power cord and
extension cord for a loose-fitting
plug.
No problem; this is normal.
The green LED will light up when
the charger is checking the
condition of the battery. This is
normal.
You need a charger with a higher
amp rate.
Have the battery checked.
Check for poor connection at
battery and frame.
Replace the in-line fuse for the ring
connector.
Replace the external battery.
15 A/12 V 10 A