Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Primary Alkaline
battery switch position
Please help in the preservation of the environment and return
used batteries to an authorized depot.
SETUP AFTER CHANGING/REPLACING THE BATTERY IN THE
SOLAR CLOCK
1.
After powering up the Solar Clock, all LCD segments will light up
briefly and it will show the time (12:00), indoor temperature, date,
and indoor humidity.
2.
After the batteries are inserted, the Solar Clock will start receiving
data signal from the solar transmitter. The outdoor temperature data
should then be displayed on the Solar Clock. If this does not happen
after 2 minutes, the batteries will need to be removed from both
units and reset from step 1.
3.
The distance between the Solar Clock and the transmitter should
not be more than 330 feet (100m) (TBA) to ensure sufficient 915
MHz transmission. (see notes on "Positioning" and "915 MHz
Reception").
Note: When changing the battery:
1.
Be careful that it does not spring free from the contacts.
2.
Press any button 20 times with the battery removed.
3.
Always wait at least 10 minutes after removing battery before
re-inserting; otherwise start up problems may occur.
TO SET THE TIME
Note: the time will be displayed with "AM" or "PM" for the time from 12:00
until 11:59.
1.
Press and hold the SET key for 3 seconds to enter the time setting
mode.
2.
The hour digits will start flashing.
3.
Set the desired hours by pressing and releasing the + key followed
by pressing the SET key.
Rechargeable Alkaline
battery switch position
5
Publicidad
Tabla de contenido
