Unpacking; Transportation; Bench Mounting; Stabiliser Bar - GMC 1800W Manual De Instrucciones

Sierra ingletadora compuesta deslizante de doble bisel
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

Unpacking

Due to modern mass production techniques, it is unlikely
that your GMC Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
1. Remove all loose parts from the carton.
2. Remove the packing materials from around the saw.
3. Using the carrying handle (8) carefully lift the saw from
the carton and place it on a level work surface.
4. The saw has been shipped with the saw arm locked in
the down position. To release the saw arm, push down
on the top of the saw arm, pull on the release knob (6),
rotate it 45° and let go, slowly raise the saw arm.
WARNING. Do not lift the saw whilst holding on to the
guards. Use the carrying handle (8).

Transportation

Lift the mitre saw only when the
saw arm is locked in the down
position, the saw is switched
off and the plug is removed
from the power point.
Only lift the saw by the
carrying handle (8) or outer
castings (Fig. A). Do not lift
the saw using the guard or
operating handle (7).

Bench mounting

The saw base has holes in
each corner to facilitate bench
mounting (Fig. B).
1. Mount the saw to a level,
horizontal bench or work
table using bolts (not
supplied) and fix the saw to
the bench using 4 bolts.
A
B
2. If desired, you can mount the saw to a piece of 13mm or
thicker plywood which can then be clamped to your work
support or moved to other job sites and re-clamped.
CAUTION. Make sure that the mounting surface is not
warped as an uneven surface can cause binding and
inaccurate sawing.

Stabiliser bar

When the saw is not fitted
to a bench, always fit the
stabiliser bar (40) into the
holes at the rear of the saw
base (Fig. C). The stabiliser
helps prevent the saw from
tipping backwards when the
slide action is used.

Release knob

The release knob (6) is
provided for holding the
cutting head down whilst
transporting or storing the
mitre saw (Fig. D). The saw
must never be used with
the release knob locking the
head down.

Slide lock

When tightened, the slide
lock (29) prevents the
saw head from sliding.
Tighten the slide lock during
transportation (Fig. E).
9
C
D
E
GB

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Db250smsDb305sms

Tabla de contenido