MAC Audio Z 4100 Modo De Empleo Y Garantia página 12

3. IMPORTANT INSTALLATION INFORMATION
• This appliance may only be connected to a 12 volt system with negative ground.
• The heat radiated when the amplifier is used means that sufficient air circulation is required at the
place of installation. It is very important that the cooler's cooler ribs do not contact any metal plating
or any surfaces which could impair air circulation. The amplifier may not be installed in small
confined spaces or spaces without air circulation (e.g. spare wheel recess or under the vehicle
carpeting). Installation in the boot is recommended.
• Install the amplifier in such a way that it is protected as far as possible against vibrations and dust
and dirt.
• Make sure that the input/output cables are sufficiently distant from the power supply cables as
otherwise interference may occur.
• Make sure that the fuse and operating elements are accessible after installation.
• The appliance's reliability and performance depend on the quality of installation. Preferably get an
expert to install the system, particularly if you want to install several loudspeakers or a complex
multi-way system.
4. CONNECTIONS
4.1 POWER SUPPLY AND AUTOMATIC SWITCHING ON
Important notice: Before commencing the installation, disconnect the plus terminals from the
car battery in order to prevent short circuits.
The power cabling usually installed in on-board car networks is not sufficient for a power amplifier's
demands. Make sure that the power lines to GND and to the +12 V terminal have been sufficiently
specified. A cable cross-section of at least 12 mm² (Z 4100) / 16 mm² (Z 4200) must be used to connect
the battery to the amplifier's terminals.
First connect the amplifier's GND terminal to the battery's minus pole. It is very important that the
connection is good. Dirt residues must be carefully removed from the battery's connection point. A loose
connection may cause malfunctions or interference noise or distortion.
The +12 V amplifier connection must then be connected with a power cable possessing an integrated
fuse to the battery's plus pole. The fuse should be located close to the battery; for safety reasons, the
cable from the positive terminal of the battery to the fuse must not exceed 60 cm in length. Only insert the
fuse when all installation work, including the connection of the loudspeakers, has been completed.
Now connect the car hi-fi receiver's remote control connection to the amplifier's REM control jack. A cable
with a cross-section of 0.75 mm² is sufficient for connecting the amplifier's REMOTE connection and the
control device.
4.2 AUDIO CABLES
When installing the audio cable between the cinch output of your car receiver and the cinch input of the
amplifier inside your car, the audio and power supply cables should, wherever possible, not be routed
along the same side of the vehicle. We recommend an isolated installation, e.g. routing the power cable
through the cable duct on the left-hand side and the audio cable through the cable duct on the right-hand
side or vice versa. This reduces interference due to crosstalk into the audio cables.
GB GB
12