Switching The Maschine On - Intimus 175 SP2 Instrucciones De Uso

GB
= Control display (fig . 2/3) „Motor overload" /
3
„Electrical fault"
To find out what to do see the relevant description
under the section „Malfunctions", p. 15.
a) „Motor overload"
Comes on when the motor has been overloaded
and has switched off. The machine cannot be
started while the motor is cooling down.
b) „Electrical fault"
Flashes when there is an electrical fault inside
the control board. The machine switches off.
Please contact your dealer.
= Control display (fig . 2/4) „Collection bin full"
4
Lit when the collection bin is full and needs to be
emptied. The cutter is switched off.
= Reverse button (fig . 2/5)
5
a) „Stop"
If you press this button briefly when the cutters
are running they switch off and stop.
b) „Reverse"
By pressing and holding this button when the
motor has stopped, the cutting mechanism runs
in reverse. The integrated LED indicator
up at the same time.
= Control display (fig . 2/6)
6
a) „Door open"
Comes on if the door on the lower part of the
machine is opened. The motor switches off au-
tomatically and cannot be started as long as the
door remains open.
b) „Door malfunction"
Flashes when there is an electrical fault in the
door sensor. The motor switches off. Please con-
tact your dealer.
= Control display (fig . 2/7)
7
a) „Oil cutters" (Machines without automatic oil
system)
Comes on when the cutters in the cross cut ver-
sion must be oiled. The lubrication procedure
must be acknowledged on the reverse but-
ton (fig. 2/5) (see description in „Cutter mainte-
nance (machines without automatic oil system)",
p. 16).
b) „To change the oil container" (Machines with
automatic oil system)
The control display flashes when the oil contai-
ner is empty and must be replaced with a full
container. The motor is switched off. The oil con-
tainer change must be acknowledged on the re-
verse button (see „Cutter maintenance (machines
with automatic oil system)", p. 16).
91239 7 08/20
175 SP2(SC2) + CP4(CC3)/CP5(CC4)/CP6(CC5)/CP7(CC6)
NOTE!
The motor is switched off when this display
flashes. The motor can only be restarted when
the empty oil container has been replaced
with a full container.
= Control display (fig . 2/8)
8
For the procedures see the relevant description
under the section „Malfunctions", p. 15.
a) „Material jam in machine"
Comes on when too much material has been
fed into the cutters. The cutters jam, then run
in reverse for a short time and stop. The motor
switches off.
b) „Light barrier covered when door open"
Comes on when there is still material in the feed
slot when the door is opened. The cutters stop.
The motor switches off.
c) „Light barrier covered when machine turned
on"
Comes on when there is still material in the feed
slot when the machine is switched on.
= Control display (fig . 2/9) „Load level of the mo-
9
lights tor"
Displays the current load level of the motor during
the shredding process via different colour lights
(see description under „Dynamic load display",
p. 14).
Light barrier
1
Feed slot
2
Light barrier
fig. 3 Light barrier
The shredding procedure starts as soon as material is
fed into the feed slot.
At the same time the integral forward button LED dis-
play comes on.

3 .2 Switching the maschine on

Press the function button (fig. 2/1) briefly.
¾ The function button LED display
"Ready".
¾ The machine can be loaded.
1
2
000151
comes on for
13