Material Feed; Emptying The Receptacle; Dynamic Load Display - Intimus 175 SP2 Instrucciones De Uso

USA

3 .3 Material feed

CAUTION!
Damage to the machine!
Ì Never feed the shredder with a quanti-
ty of material exceeding the maximum
indicated. Refer to „Technical Data",
p. 18!
Ì Should the machine become overloa-
ded, follow the instructions under „Ma-
terial jam in the machine", p. 15.
Feed paper to the cutting mechanism through the
feed slot (fig. 3/1).
¾ Machine switches automatically to forward and
draws paper in.
¾ The motor switches off automatically after
shredding.
NOTE!
For shredding transparent films, the machi-
ne must be manually switched to forwards
running (press and hold the forwards button
(fig. 2/2)).
If the machine is not used for a period of approx.
15 mins., it automatically switches off.

3 .4 Emptying the receptacle

1
Receptacle
2
Door
fig. 4 Receptacle
The motor switches off if the receptacle is full. The con-
trol display (fig. 2/4) comes on.
6
Translation of the Original Operating Manual
Übersetzung der Originalbetriebsanleitung
NOTE!
To complete the shredding process when the
motor is switched off, press and hold the for-
ward button (fig. 2/2).
¾ The cutting mechanism continues to
This process can only be activated once.
Empty the receptacle as follows:
1 . Open the door (fig. 4/2).
¾ The control display
¾ If there is still material in the feed slot, the con-
trol display
2 . Remove the bag and dispose of the contents.
¾ The control display
3 . Place empty sack into receptacle.
4 . Close the door.
¾ The control display
5 . If the control display
ward button (fig. 2/2) briefly. The remaining mate-
rial in the feed slot is shredded and the display go
out.
NOTE!
The machine will only run if the door is closed!

3 .5 Dynamic load display

During the shredding process, an LED control indicator
(fig. 2/9) displays the extent of the load on the motor:
• Green light:
• Red light:
The control display should remain on green to avoid a
material jam!
NOTE!
The load display system calibrates automati-
cally! By that the load display can differ (e.g.
1
at idle speed the control display comes on in
red). That is no quality deficit. After several
shredding processes the load display norma-
2
lizes.
000153
run forward for approx. four seconds.
(fig. 2/6) comes on.
(fig. 2/8) also comes on.
(fig. 2/4) goes out.
(fig. 2/6) goes out.
comes on, press the for-
load < 75 %
load 75 - 100 %
91239 7 08/20