Wiring Connection - Davey SILENSOR Instalación E Instrucciones De Funcionamiento

Wiring Connection

Please refer to the below schematic for information on how to correctly install your pump.
All single phase Silensor models have manual re-set thermal overload protection built in, i.e.
should overload on motor cause thermal to open circuit and switch motor off, it will not re-set
and switch motor on until power to the motor has been turned off and then turned back on.
Davey Water Products recommends that all installations are fitted with
earth leakage or residual current protection devices.
CAUTION:
In the interest of safety, we advise that all brands and types of pool pumps
must be installed in accordance with AS3000/IEC 60335-2-41 wiring rules
or equivalent
If the pump and filter are located below pool water level, it is necessary
to fit isolating valves in the pipe between the pump and the skimmer box
and in the return pipe from the filter to the pool.
The fittings on this product are constructed of ABS. Some PVC jointing
compounds are incompatible with ABS. Check compound suitability
before use.
Warning!
easy access so that the pump can be switched off in an emergency.
E
PART No.13567
Ensure that an electrical isolation switch is located with
4
CAPACITOR