Programming; To Erase The Memory - Craftsman 139.3043 Manual Del Propietário

Programming

Your garage door opener has been programmed at the factory to operate with your remote control. Older Craftsman
are not compatible, see page 41 for compatible accessories. Programming can be done through the door control or the learn button on
the garage door opener. To program additional remote controls refer to the instructions provided with the additional remote controls.
IMPORTANT NOTE: If your vehicle is equipped with a Homelink
and year of your vehicle. Visit www.homelink.com for additional information.
PROGRAM A REMOTE USING THE LEARN BUTTON
1. Press and release the Learn
button on the garage door opener. The
Learn indicator light will glow steadily for
30 seconds.
2. Within 30 seconds, press and hold the
button on the remote control.
3. Release the button when the garage door
opener light blinks. It has learned the
code. If light bulbs are not installed, two
clicks will be heard.
When replacing the light lens cover, ensure the antenna wires are
hanging straight down.

To Erase the Memory

ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Press and hold the learn button on garage door opener
until the learn LED goes out (approximately 6 seconds). All
remote control and keyless entry codes are now erased.
Reprogram any accessory you wish to use.
® , you may require an external adapter depending on the make, model
TO ADD, REPROGRAM, OR CHANGE A REMOTE CONTROL/
KEYLESS ENTRY PIN USING THE SMART CONTROL PANEL
1. Press the navigation button below
"MENU" to view the Features menu.
2. Use the navigation buttons to scroll to
"PROGRAM" and press the navigation
button under to continue.
3. Select "REMOTE" or "KEYPAD" to
program from the program menu.
Press to continue.
4. Press the button on the remote
control that you wish to operate your
garage door.
OR
Enter a 4-digit personal identification
number (PIN) of your choice on the
keyless entry keypad. Then press the
ENTER button.
ERASE ALL DEVICES (INCLUDING ASSURELINK
1. Press and hold the learn button on garage door opener until the
learn LED goes out (approximately 6 seconds).
2. Immediately press and hold the learn button again until the
learn LED goes out. All codes are now erased.
Reprogram any accessory you wish to use.
35
® accessories
TO TO REMOTE REMOTE
OR
? ? ? ?
PIN
TM
ACCESSORIES)