Heath Zenith 7143 Manual Del Usario página 2

INSTALLATION
Mounting the Solar Light Fixture:
For best performance, mount the solar light fixture about 6
feet (1.8 m) above the ground. Note: Ensure the fixture
and the solar panel are located close enough together
for the cord to reach.
1. Pull the locking tab away from the light and slide the
mounting plate down to remove.
Wall Plate
Locking Tab
2. Using a 3/16" drill bit, drill pilot holes for the wall an-
chors and insert two wall anchors. Install the mounting
plate using two screws. Make sure there is enough
vertical space above the mounting plate to allow the
light fixture to be mounted.
3. Slide the rear of the battery case down onto the wall
mounting plate until it snaps into place.
Mounting the Solar Panel:
1. Using a 3/16" drill bit, drill pilot holes for the wall anchors
and insert three wall anchors. Mount the solar panel
using four screws. IMPORTANT: Caulk around the
base and on top of the screw heads after instal-
lation.
2. Adjust the angle of the solar panel by grasping the
panel and gently rotating it up or down as needed.
Remember, the solar panel must receive as much
direct sunlight over the course of the day as possible.
Keep in mind that shadows may block the sunlight
from reaching the solar panel during the day.
2
207197-02