Selecting A Suitable Location - Marmitek HOMEGUARD MS8000 Manual Del Usario

5. led indicator: Indicator flashes if remote transmits a command. If indicator does not flash
or lights up weakly, replace the batteries. The battery holder is located inside the remote.
The back of the remote can be easily opened using your fingernails or a small screwdriver.
Only use two 3V lithium batteries model CR2016. Push the ARM key for more than 3
seconds and release the button; the indicator blinks. If batteries are replaced, you have to
reregister with the base station (refer to installation).

4. seLeCTINg a suITaBLe LoCaTIoN

The base station has a so-called passive infrared element that detects any change in temperature
within its range. A certain amount of heat related to human beings is detected for an alarm.
However to achieve the best performance of your HomeGuard, note following installation
recommendations before installing:
a. It should be located at approx. 170-180cm height on a fixed vertical surface e.g. wall or
cupboard
b. Choose a location where an intruder may pass the monitored area at all time in an early
stage of intrusion.
c. Choose a location near to a wall outlet and telephone socket.
d. The sensor should not be placed above or near heating elements or in front of air-
conditioners.
e. Do not mount the sensor on a metal surface or next to electrical equipment such as TV sets
or computers.
caution:
a. Radio equipment (e.g. wireless headphones or loudspeakers) working on a frequency band
of 433MHz will not create a false alarm, however, these devices will limit the RF range of
the remote control considerably.
b. Pets, e.g. dogs or cats, may trigger the alarm, and should therefore not be kept in the same
room as where the activated sensor is mounted.
5. PIN Code seTTINg:
Your HomeGuard can be operated and programmed by using a so-called PIN code (Personal
Identification Number). The factory default code is: [0000]. To avoid unauthorised use, enter
your own PIN code.
note: Choose a code you will easily remember, since the HomeGuard will recognise this code
only for further operation.
1. Enter your current PIN (Personal Identification Number). If you have never changed this code
before, the factory default code is [0000]. You will hear three high tones and one low tone
as confirmation. The green indicator will start flashing.
2. Press 5 on the keyboard of the HomeGuard: One low tone is given for confirmation.
3. Enter a new 4-digit PIN code: You will get three high tones and one low tone as confirmation
and the indicator stops flashing.
HomeGuard™ 5