Frequently Asked Questions - Marmitek HOMEGUARD MS8000 Manual Del Usario

To activate the security system from the keyboard (always delayed):
Enter your PIN (Personal Identification Number). Factory default is [0000]: You will hear three
high tones and one low tone as confirmation. The green indicator starts flashing. Press # in
the keyboard: You will hear one low tone as confirmation and the RED indicator lights up, the
GREEN indicator will flash during the delay (30 seconds). After 30 seconds the HomeGuard is
armed and will generate one low tone for confirmation.
to disarm the HomeGuard via the keyboard:
1. Enter your PIN code: 4 short tones will be generated as confirmation.
2. Press [ * ] : One short tone will be generated and the RED indicator will go out.
to arm and disarm the HomeGuard with the remote control:
1. Press ARM to activate the alarm.
2. Press DISARM to de-activate the HomeGuard. If you use the remote, the arming and
disarming may be instant of delayed, depending on the settings of the HomeGuard.
to generate a panic call: press both panic buttons at the same time.
to reset the alarm:
If an alarm has occurred it can be reset by:
1. The person called pressing 0 on the telephone dialler just after the beep(s) in the message.
2. Disarming the system on the keyboard by entering your PIN followed by [ * ]
3. Pressing DISARM on the remote control.
alarm message:
During an alarm the telephone dialler will dial the first number. It will start transmitting the
pre-recorder message as soon as the last digit has been dialled. The message lasts 9 seconds
and will be repeated twice. The pre-recorded message is followed by a beep. After this beep
the system will wait for call confirmation which can be given by pressing 0 on a DTMF (touch
tone) telephone. In case the confirmation is not received, the HomeGuard will start dialling
the second number and follow the same procedure. If the second person does not give
confirmation, the third number will be dialled.
note:
Instruct the person who's number has been entered to give the confirmation 0 just after the
beep(s). Since telephone answering machines or voice mail facilities will not generate the
confirmation, these will be ignored. It is recommended to do a test with the people involved in
order to let everyone get acquainted with the system.

12. FreQueNTLY asKed QuesTIoNs

the base station does not react at all, the green indicator is not on
Check the power supply and/or the replace the back-up battery.
8 © marmiteK