Marmitek HOMEGUARD MS8000 Manual Del Usario página 6

6. ProgrammINg oF TeLePhoNe NumBers.
You may select up to three telephone numbers to be contacted if the alarm is triggered. These
numbers may include mobile (GSM) numbers, however you are not allowed to use national
emergency numbers from e.g. police, paramedical, etc. The numbers you chose should be have
well informed people, instructed by you and able to help in case of an alarm (e.g. neighbours,
friends, relatives or your own mobile).
To enter telephone numbers:
1. Enter your PIN (Personal Identification Number). Factory default is [0000]: You will hear
three high tones and one low tone as confirmation. The green indicator starts flashing.
2. Press 2 on the keyboard of the HomeGuard: One low tone is given for confirmation.
3. Press the [ * ] button: One high tone is given for confirmation.
4. Enter the first telephone number you selected (max. 16 digits). If a dialling pause is required
(e.g. with a certain type of PABX between 0 and the number you want to dialled in order
to obtain an outside line) press another [ * ] for a one second pause. One high tone is given
for confirmation of each number entered.
5. Press #: One high tone is given for confirmation.
6. Press 1 to place the telephone number you just entered in memory location 1. One short
low tone is given and the green indicator stops flashing. Repeat this procedure with the
two other selected telephone numbers by pressing 2 and 3 for placing these in memory
positions 2 and 3 respectively. Note: All three numbers should be entered. You may enter
the same number more than once.
call identification:
If you select telephone numbers of people who's number has been entered by more than
one HomeGuard, you can transmit an extra audible signal with the pre-recorded message in
order to identify the HomeGuard calling. The factory default is one beep at the end of the
message.
to change the number of beeps (1, 2 or 3):
1. Enter your PIN
2. Press 4 on the keyboard
3. Press 1, 2 or 3 for the required number of identification beeps.
7. regIsTerINg remoTe CoNTroLs
HomeGuard can be remotely controlled by up to 4 radio remotes (1 piece KR21E supplied). For
security reasons, each remote selects a unique code (1 out of 65.536) after the battery has
been installed. Before using HomeGuard, the base station has to learn this specific code from
each remote:
1. Enter your PIN (Personal Identification Number). Factory default is [0000] see (5): You
will hear three high tones and one low tone as confirmation. The green indicator starts
flashing.
6 © marmiteK