Operating Your Whirlpool; Care And Cleaning Instructions - Kohler K-1109 Manual Del Usuario

Turn the jet trim
ring clockwise to
decrease the flow.

Operating Your Whirlpool

Position the jet nozzles so they face down toward the basin. Turn the jet trim rings fully
counterclockwise.
NOTE: The water temperature in the whirlpool should never exceed 104° F (40° C).
Close the drain, and fill the whirlpool to a level at least 2" (5 cm) above the top of the highest jet.
Use your hand to test the water temperature for comfort and safety, then carefully enter the bath
basin.
Press the air actuator to turn on the whirlpool.
Adjust the jets for optimum air/water mixture. Turn the jet trim rings clockwise to reduce the flow,
and counterclockwise to increase the flow. Position the jet nozzles to direct the water flow as desired
to maximize your hydro-massage experience.
Press the air actuator a second time to turn off the whirlpool.
Carefully exit the bath, and open the drain to empty the whirlpool.
NOTE: If the whirlpool does not function properly, please refer to the Troubleshooting section.

Care and Cleaning Instructions

Cleaning Your Acrylic Bath Whirlpool
Do not use abrasive cleansers or solvents on acrylic surfaces.
Wipe out your acrylic whirlpool with a soft cloth after each use.
Avoid detergents, disinfectants, or cleaning products in aerosol cans.
If the surface gets excessively dirty you can use a general purpose cleaner such as: Formula 409
Purpose Cleaner, Gel Gloss
Clean Lemon Fresh, Cinch
®
NOTE: To restore dull or scratched units: Apply white automotive polishing compound with a clean rag.
Rub scratches and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste
wax. Do not wax areas where you walk or stand.
Flushing Your Whirlpool System
Flush your whirlpool system twice a month or more, depending upon usage. Use the following
sequence:
• Turn the jet trim rings fully clockwise to reduce air induction.
• Fill the whirlpool with hot water to a level at least 2" (5 cm) above the highest jet.
Kohler Co.
Fill with water 2" (5.1 cm)
above the highest jet.
Position the jet
nozzles to direct
the water flow as
desired.
Turn the jet trim ring
counterclockwise to
increase the flow.
(Bath and Shower only), Scrub Free
®
, Glass Plus , or Fantastik
® ®
Press the air actuator to turn
on and off the whirlpool.
Mildew Stain Remover, Mr.
®
All Purpose.
®
5
All
®
1010997-5-E