Iberspa READY2ENJOY Manual De Funcionamiento página 12

1. Ensure the power pack is not plugged in.
2. Remove the protective caps from the suction
and discharge fittings inside the spa. Place
the caps in a safe location.
3. Using a garden hose, fill the spa to
approximately one inch above the top of the
second air chamber ring. Be careful not to
over fill the spa, or the spa may overflow
during use. Each average adult will raise the
water level in the spa approximately two
inches, and the turbo wave blower action will
raise water level an additional three to four
inches.
4. Bleed the air from the filter tank by turning
the small black knob on the top of the filter
tank counterclockwise. Allow the filter tank
to bleed for approximately one minute, or
until water drips from the fitting. Turn the
fitting clock-wise to close the bleed valve.
5. Plug the power pack into the electrical outlet.
The water pump will turn on and begin
pumping water. Water should flow from the small return nozzle on the
bottom inside wall of the spa behind the power pack.
flowing from the return nozzle, repeat the air bleeding instructions provided
in step 4. Unplug the power pack while bleeding air.
NOTE: If the air is not properly bled from the ilter tank, the water
pump will be air bound and no water will flow. This will prevent
the spa from heating, and the water will not be filtered. Make sure
water is flowing from the return nozzle before continuing.
6. Place the inflatable bladder cover on the spa.
centered on the Spa.
7. Place the top cover the spa and line up the eight cover locks.
8. Connect the eight clips to secure the cover in place. The clips may belocked
using the small keys provided in the patch kit.
FILLING THE SPA
If water is not
Make sure the cover is
ENGLISH