Iberspa READY2ENJOY Manual De Funcionamiento página 6

WARNINGS
1. Never use an extension cord to connect the Power Pack to a power source. The cord
could cause a voltage drop which may cause damage to the control and pump
motor.
2. Always operate Power Pack with the cord mounted GFCI in place and functional on
120 volt units. Failure to do so could result in a shock hazard.
3. Always operate spa with sufficient water. Water level must be above suction inlets.
Insufficient water will cause pump failure and void warranty.
4. Maintain proper water pH (7.4 - 7.6 is ideal). Failure to do so may cause damage to
vinyl liner, heater element, and damage will not be covered by warranty.
5. Install spa only on floors or areas that can withstand repeated water exposure.
Equipment failure as well as splashing, filling and draining will spill water. If located
in a multi - story building, care must be taken to protect the objects on the floors
below.
6. Install only on floors that can withstand the floor loading of your spa. If in doubt,
please consult an architect or engineer to determine the floor rating before filing.
See specifications.
7. Do not open Power Pack or the GFCI. O pening either component will void the
warranty.
8. When storing, always drain all water from tub, plumbing and Power Pack, especially
in freezing temperature as freeze damage is not covered by warranty.
9. Always maintain proper water sanitation with chemicals and routine cleaning. Warm
water is an ideal place for bacteria to thrive. It's your sole responsibility to maintain
proper water sanitation. Read the sections on water chemistry and filter
maintenance.
10.Never add water to chemicals. Always add chemicals to water to avoid strong fumes
or violent reactions that may result in hazardous chemical spray.
SAVE THESE INSTRUCTIONS
ENGLISH