Temperature Control - Iberspa READY2ENJOY Manual De Funcionamiento

Ÿ Test the GFCI before each use. (Refer to the instructions
provided in the Maintenance section of this manual.)
Ÿ Plug into properly grounded receptacle.
Ÿ Do not use extension cords.

Temperature Control

1. During normal operation, the control
display on the top of the power pack
displays the current water temperature.
2. To set the desired water temperature,
press and release the up or down heat
button. The display will flash the desired
water temperature set point. To change
the set point, press the up or down button once for each degree of water
temperature, to a maximum of 104ºF (40ºC).
3. After a few seconds pass without pressing either heat button, the display
will return to the current water temperature. The spa will begin heating to
the desired water temperature at a rate of approximately 1 to 1-1/2
degrees F per hour.
4. The spa is made to hold the set temperature. Do not lower the
temperature set point after use. The heater will turn on and off
automatically to maintain the desired temperature.
5. In case of electric power interruption, the spa temperature set point will
default to 100ºF when electric power is restored.
OPERATION
ENGLISH