Belkin F5D7632 Manual De Usuario página 26

Manually Configuring your Router
2. Subnet Mask
3. Default Route
Enter a default gateway IP address. If the Router cannot find the
destination address within its local network, it will forward the
packets to the default gateway assigned by your ISP.
4. VPI/VCI
- Enter your Virtual Path Identifier (VPI) and Virtual
Circuit Identifier
(VCI) parameter here. These identifiers are assigned by your ISP.
5. Encapsulation
Setting your Connection Type to Modem
Only (Disable Internet Sharing)
In this mode, the Router simply acts as a bridge passing packets across
the DSL port. It requires additional software to be installed on your
computers in order to access the Internet.
1. VPI/VCI
- Enter your Virtual Path Identifier (VPI) and Virtual
Circuit Identifier (VCI) parameter here. (Assigned by your ISP).
2. Encapsulation
DNS (Domain Name Server) Settings
A "Domain Name Server" is a server located on the Internet that translates
Universal Resource Links (URLs) like "www.belkin.com" to IP addresses.
Many ISPs do not require you to enter this information into the Router. The
"Automatic from ISP" box (1) should be checked if your ISP did not give
you a specific DNS address. If you are using a static IP connection type,
then you may need to enter a specific DNS address and secondary DNS
address for your connection to work properly. If your connection type is
dynamic or PPPoE, it is likely that you do not have to enter a DNS address.
- Enter a subnet mask assigned by your ISP.
-
- Select LLC or VC MUX your ISP uses.
- Select LLC or VC MUX. (Assigned by your ISP).
26 26