Cleaning The Nozzle - Bissell PROHEAT 2X REVOLUTION 1548 Serie Guia Del Usuario

Cleaning Machine After Use
WARNING
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from electrical
outlet before performing maintenance or troubleshooting.
1
Rinse the Clean Water Tank
with warm tap water. Fill the
tank with warm tap water,
twist the cap on and return
the tank to the machine.
Twist cap back on tightly.
NOTE: Be sure to clean the Brush Rolls
and Nozzle before storing your machine.
Follow these steps if your Nozzle
becomes clogged with hair or debris.

Cleaning the Nozzle

1
3
Hold the nozzle and insert the Nozzle
Clean Out Tool into the thin slot at the
front of the nozzle where it touches the
floor. Clean until free of pet hair or debris.
To flush and rinse machine
turn it ON and press the
Spray Trigger for 15 seconds
while making forward and
backward passes on carpet.
Release the trigger and suck
up water.
If pet hair or debris
become clogged
in the nozzle, it can
be cleaned out of
the nozzle with the
Nozzle Clean Out
Tool.
Turn OFF and
unplug the machine.
See page 14 to clean the
Dirty Water Tank from
the water that was just
sucked up. Empty the Clean
Water Tank and let dry
before storing. Wipe your
machine's exterior with a
soft cloth.
NOTICE
To reduce the risk of a leaking
condition, do not store unit where freezing may occur.
Damage to internal components may result.
2
Remove the nozzle from the foot: flip the
Accessory Hose Door open and lift up on
the nozzle and Accessory Hose Door.
4
Return the nozzle back
to the foot of the
machine. Line up the
three hooks on the
nozzle to the bottom of
the foot (see arrows for location).
Rotate the nozzle up and click into place.
Close the Accessory Hose Door.
www.BISSELL.com
15