Troubleshooting - Tomahawk TMD14 Manual De Usuario

Ocultar thumbs Ver también para TMD14:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

(5)Stating engine
a.Put the dust gate handle to the lowest
position before starting the engine, otherwise
chemicals will be jetted when starting
engine.
b.It is prohibited to stand in front of nozzle.
Even though dust gateis closed, residual
dust in pipe will be blown out.
(6)Misting/Dusting
weather with little wind. For example, in
the early morning or in the late afternoon,
this can reduce the evaporation and drift of
chemicals and improve the protecting effect.
b.Operator should move windward.
c.Review area to be cleared. Look for
potential hazards such as stones or metal
objects. Spectators and fellow workers
must be warned, and children and animals
prevented from coming nearer than 15m
while the blower is in use. Do not point the
blowy pipe at people or animals.
d.If your mouth or eyes are spattered with
chemicals, wash them with clean water and
then go to see a doctor immediately.
r.
e . I f t h e o p e r a t o r h a s a h e a d a c h e o r
dizziness, stop working at once and go to
see a doctor in time.
Fig 12
f.For the operator's safety, misting/dusting
must be carried out strictly according to the
instruction of the chemicals and agricultural
requirements.
8.Troubles and Remedies
(1)Engine starts difficultly or cannot start.
Check if the spark
plug has sparked-over.
Screw down the spark
plug,put the side
pole to touch the cylinder.Pull the starter
and watch between the poles of spark
plug whether there are sparks.Pull the
starter carefully,do not touch the metal part
of spark
plug to prevent from being
shocked as shown in Fig.12.
-10-

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido