Technical Specifications - GYS NOMAD POWER 30 COMPRESSOR Manual Del Usuario

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Translation of the original instructions

USING AS BLAST PUMP

12V/10A power supply to the blast pump

1. lnsert one end of the blast pump power cable into the 12V output port

2. lnsert another end of the blast pump power cable into the car cigarette lighter

3. Press the switch button

Blast pump instruction

1. Connect the air hose to the air outlet

2. Select the «PSl,BAR,KPA, KG/CM2» unit of the compressor with the button

3. C hoosethevalueuptowhichthecompressorshouldinflatethetirewiththebuttons

decrease a minimum unit, long press the button can quickly increase / decrease the value.

4. Pressing the switch of the blast pump for 3 s to normal start.

5. W henthepumpreachtoaspecifiedvalue,itwillshutdownautomatically,toavoiddamagingthetire.Tostop

before the requested value is reached, quickly press the buttons

USING AS POWER SUPPLY

For Cell Phone or Tablet Instruction

1. Plug the switch cable to USB 5V 2A output port

2. Select appropriate connector and connect it to your mobile phones or tablet.

3. Press the switch button

For power apply to 12 V vehicle products or 12 V electronics

1. Plug the optional switch cable to 12 V 10 A output port

2. Connect the optional switch cable and 12 V vehicle product or 12 V electronics.

3. Press the switch button

USING AS LED FLASH LIGHT

There are 4 modes of LED light appear in order (normal. strobe. SOS. off) if you press slightly.

1. Press the switch button

2. On the basis of white LED light lit, press the switch again, white leds into Flash mode.

3. On the basis of < 5 >, press the switch button again, the white LED light into the SOS mode.

4. On the basis of < 6 >, press the switch button again, white LED light off.