Care And Maintenance ⑪; Filter Cleaning; Warranty Conditions - Comet Spa CVP 278 P Traducción De Las Instrucciones Originales

electrician.
Periodically examine the power cord and machine
•
for damage. If any damage is found, do not use
the appliance but contact your service centre for
repair.
If the supply cord is damaged, it must be replaced
•
by the manufacturer, its service centres or similarly
qualified people in order to avoid a hazard.
If an extension cord is used, the plug and socket must
•
be of watertight construction.
Before vacuuming liquids, check the float functions
•
correctly. When vacuuming liquids, and when the
tank is full, a float closes the suction opening, and the
vacuum operation is interrupted. Then switch off the
machine, disconnect the plug and empty the tank.
Regularly clean the water level limiting device (float)
and examine it for signs of damages.
If the machine overturns, it would be recommended
•
to stand it up before switching off.
If foam or liquid escape from the appliance, switch off
•
immediately.
The equipment should not be used to vacuum wa-
•
ter from containers lavatories, tubs, etc.
Aggressive solvents or detergents should not be
•
used.
Service and repairs must be carried out by qualified
•
personnel only. Only use manufacturer original spare
parts for service repair.
The manufacturer cannot be held responsible for any
•
damage/injury caused to persons, animals or property
caused by misuse of the appliance, not in compliance
with manual instructions.
USE
(see fig. ③④⑤⑥
• Be sure that switch is in off position (0) OFF and
connect the machine to a suitable socket.
• The machine must be always kept on horizontal bases,
in a safe and stable way.
• Insert the suitable filters for the proper use.
Never use the appliance without filters .
•
• Use the most suitable accessories for the requested
usage.
• Put switch on (I) ON position in order to start the
machine.
• When job is over, switch off (0) OFF and keep away the
plug from the socket.
• If the appliance is used with especially fine dust
(size below 0.3 µm) the filter supplied will require
cleaning more frequently. For especially demanding
applications, the use of specific filters supplied as an
optional (Hepa) may be necessary.
⑧ Pneumatic filter shaker U : If there should be a
reduction in the suction power, operate quickly the
filter reset lever U several times to reset the filter .
CARE AND MAINTENANCE ⑪
The machine shall be disconnected from its power
•
source, by removing the plug from the socket-outlet,
during cleaning or maintenance
• Clean the exterior part of the machine with a dry
cloth.
• Move the appliance only by catching the carrying
handle located on the motor head.
• Store the appliance and the accessories in a dry safe
place, out of the reach of children.
Before emptying the tank, switch off the machine and
•
disconnect the plug from the socket outlet.

FILTER CLEANING

1- Remove the filter R1
Filter shaker R1
2-
Once the filter has been cleaned, check whether it
•
is suitable for further use. If it has been damaged or
broken, replace it with an original filter.

WARRANTY CONDITIONS

All our machines are subjected to strict tests and are covered
against manufacturing defects in accordance with applicable re-
gulations. The warranty is effective from the date of purchase.
The following are not included in the warranty: - Parts subject to
normal wear. - Rubber parts, charcoal, filters and the accessories
and optional accessories. - Accidental damage, caused by tran-
sport, neglect or inadequate treatment, incorrect or improper use
and installation failing - The warranty shall not cover any cleaning
operations to which the operative components may be subjected,
such as clogged nozzles and filter blocked due to limestones.
DISPOSAL (WEEE)
As the owner of electrical or electronic equipment, the law (in
accordance with the EU Directive 2012/19/EU on waste from
electrical and electronic equipment and the national laws of the
EU Member States that have implemented this Directive) prohibits
you from disposing of this product or its electrical / electronic ac-
cessories as municipal solid waste and obliges you to make use of
the appropriate waste collection facilities.The product can be di-
sposed of by returning it to the distributor when a new product is
purchased. The new product must be equivalent to that being di-
sposed of. Disposing of the product in the environment can cause
great harm to the environment itself and human health.
The symbol in the figure indicates the urban waste containers
and it is strictly prohibited to dispose of the equipment in these
containers. Non-compliance with the regulations stipulated in the
Directive 2012/19/EU and the decrees implemented in the various
EU Member States is administratively punishable.
9