ENGLISH
DI 2850 digital control unit
- DI 2850 230V
- DI 2850 120V
- DI 2850 100V
All soldering handpieces and hot tweezers of our
Advanced range can be used with the DI 2850
always using the corresponding stand.
The station's components:
DI 2850 230V Ref. 2850200
- DI 2850 230V control unit
- Connection cable to mains
- Instructions manual
DI 2850 120V Ref. 2850100
- DI 2850 120V control unit
- Connection cable to mains
- Instructions manual
DI 2850 100V Ref. 2850110
- DI 2850 100V control unit
- Connection cable to mains
- Instructions manual
Kit DI 2850 -2245 230V Ref.2850230
- DI 2850 230V control unit
- 2245 handpiece
- AD 8245 stand
- 2245-003 cartridge
Kit DI 2850 -2210 230V Ref.2850231
- DI 2850 230V control unit
- 2210 handpiece
- AD 8210 stand
- 2210-001 cartridge
Speak to your distributor for more kits.
Technical specifications
- Temperature selection from 90 to 450°C or
Ref. 2850200
190 to 840°F (±5%).
Ref. 2850100
- Power: 75W.
Ref. 2850110
- Safety transformer, mains separator and
double isolation, with integrated temperature
protection fuse.
- DI 2850 230V control unit
Input: 230V 50Hz. Output: 24V.
- DI 2850 120V control unit
Input: 120V 60Hz. Output: 24V.
- DI 2850 100V control unit
Ref. 0269300
Input: 100V 60Hz. Output: 24V.
- Total weight of unit: 2,5Kg (6,25lbs).
- ESD protected housing "skin effect".
Typical surface resistance: 10
square.
Ref. 0269320
- Complies with CE standards on electrical
safety, electromagnetic compatibility and
antistatic protection.
- Equipotential connector and the tool tip are
Ref. 0269320
connected to station mains ground supply for
ESD protection.
Ref. 2850200
Ref. 2245000
Ref. 0788245
Ref. 2245003
Ref. 2850200
RECOMMENDATIONS FOR USE
Ref. 2210000
For soldering and desoldering
Ref. 0788210
Ref. 2210001
-
-
-
Safety measures
-
-
-
-
-
2
This product should not be thrown in the
garbadge.
Clean the contacts and the printed circuit
to be desoldered of dust or dirt.
Preferably select a temperature below
350°C (662ºF). Excess temperature may
cause the printed circuit tracks to break
loose.
The tip must be well tinned for good heat
conduction. If it has been inoperative for
any length of time, it should be retinned.
Incorrect use of this tool may cause fire.
Be cautious when using the tool in places
where inflamable products are stored.
Heat can cause fire to inflamable products
even when they are not in sight.
Do not use when the atmosphere is
explosive.
Place the tool back on its stand in order to
let it cool down before you store it.
Ref. 2850200
Ref. 2850100
Ref. 2850110
5
11
-10
Ohms/