Measure The Installation; Prepare The Hood - Broan Elite EW5830SS Instrucciones

MEASURE THE INSTALLATION

6"
ROUND DUCT
DECORATIVE FLUE
3½"
FROM WALL TO
CENTER LINE OF DUCT
( :
NOTE CENTERLINE OF
¾"
BLOWER IS LEFT OF
.)
CENTERLINE OF HOOD
DECORATIVE FLUE
5
1 / "
8
24"
TO
COOKING SURFACE
The minimum hood distance above cooktop MUST NOT BE
LESS than 24" .
A maximum of 36" above cooktop is highly recommended for
best capture of cooking impurities.
Distances over 36" are at the installer and users discretion;
providing that the ceiling height permits.
INSTALL THE DUCTWORK
(Ducted Hoods Only)
1. Decide where the ductwork will run between the hood and
the outside.
2. A straight, short duct run will allow the hood to perform most
efficiently.
3. Long duct runs, elbows and transitions will reduce the
performance of the hood. Use as few of them as possible.
Larger ducting may be required for best performance with
longer duct runs.
4. Install wall cap or roof cap. Connect round metal ductwork
to cap and work back towards the hood location. Use duct
tape to seal the joints between ductwork sections.
NOTE
Centerline of duct connector on hood is ¾" to the left of the
centerline of the hood – plan duct rough-in accordingly.
ROOF CAP
ROUND ELBOW
WALL CAP
HOOD MOUNTING
BRACKET
3
12 / "
TO CENTER
8
OF UPPER BRACKET
HOLES
HOOD
2"
TO CENTER
OF LOWER HOOD
36"
CHASIS HOLES
ABOVE
MODELS EW5830SS • EW5836SS

PREPARE THE HOOD

Unpack hood and check contents. You should receive:
1 - Hood Assembly
1 - Decorative Flue Assembly (consisting of upper and lower
flue)
1 - Upper Flue Mounting Bracket
2 - Aluminum Grease Filters (installed on hood)
2 - 35W MR16 GU10 Halogen Lamps (installed on hood)
1 - Parts Bag containing:
6 - Mounting Screws (4mm x 38mm Cross Recessed Pan Head)
2 - Mounting Screws (4mm x 12mm Cross Recessed Pan Head)
1 - Suction Cup Tool
1 - Installation Manual
UPPER
FLUE MOUNTING
BRACKET
2 MOUNTING
SCREWS
(4mm x 12mm
Cross Recessed
Pan Head)
BULB
SUCTION
CUP TOOL
Page 2
6 MOUNTING
SCREWS
(4mm x 38mm
Cross Recessed
Pan Head)
DECORATIVE
FLUE
ASSEMBLY
HOOD
ASSEMBLY