Install Ductwork; Prepare The Installation - Broan Elite E662E Instrucciones De Instalación

1. INSTALL DUCTWORK

The Broan Elite model E662E range hood must be installed with exterior blower 331H, 332H, 335 and 336 only. Other
blowers cannot be substituted (blowers sold separately).
Plan where and how the ductwork will be installed. Install proper-sized ductwork, elbows, etc. Use 2" duct tape to seal
duct joints.
The minimum hood distance above cooktop must not be less than 24". A maximum of 30" above cooktop is
highly recommended for best capture of cooking impurities.
Distances over 30" are at the installer and users discretion.

2. PREPARE THE INSTALLATION

Make sure that the following items are included:
- Hood
- Accessories:
• Filters (2 for 30'' and 36'' width hoods, 3 for 42'' width hood)
• Bag of parts (inside one filler) including:
(2) wire clamps, (5) #8 x
Parts sold separately:
- Exterior blower model 331H, 332H, 335 or 336
- Halogen lights (MR16, GU10, 120V, 50W)
- Ducts, elbows, dampers. Refer to page 1 for a complete list of venting options and model number.
NOTES: 1. During installation, protect countertop and/or cooktop.
2. If the bottom of the cabinet is recessed, attach three 1" width wood strip (not included). Refer to figure
below for wood strips proper location.
Exterior blower
10" round duct
24" minimum above
cooking surface
HH0047A
1 ⁄ " screws, (3) wire connectors, (9) #8 x
2
CABINET BOTTOM
1"
1"
10¼''
1¾''
HO0045A
- 2 -
Hood
3 ⁄ " screws
8
1"
1¾''