Connect End Rail Clamps, 20" Tubing And Elbows; Connect Plain And Swedged Tubing - Radio System Corporation PetSafe E-Z Roof Instrucciones De Ensamblado

Step Connect End Rail Clamps,
1
20" Tubing and Elbows
1. Gather 4 end rail clamps, 2 - 20" tubes, 2 elbows, 2
carriage bolts and 2 nuts.
2. Insert 1 elbow into 1 - 20" tube.
3. Beginning on the gate panel side, attach 2 end rail
clamps to top frame of the kennel panel. Position
end rail clamps in the center of the gate panel.
4. Install 20" tube with elbow into end rail clamps and
tighten with 1 carriage bolt and 1 nut.
5. Repeat steps 2 through 4 on opposite side of kennel.
Loosely secure the end rail clamps to the kennel
frame.
__________________________________________________________________________________________________

Connect Plain and Swedged Tubing

Step
2
1. Gather 1 plain 41.5" tube and 2 swedged 41" tubes.
2. Beginning on the gate panel side, insert one swedged
tube into elbow. Then insert plain tube over swedged
tube. Finish by inserting remaining swedged tube
into plain tube and opposite elbow.
3. Tighten end rail clamps after all tubing is assembled.
4 1-888-632-4453