Safety Measures And Training The Final User; Use Of The Equipment 4; Setting The Goods On The Slicer Saddle; Generalities And Products For Cleaning - CELME GPE 250 CE Manual De Producto

SAFETY MEASURES AND TRAINING THE FINAL USER

THE SKILLED
CONNECTIONS IS RESPONSIBLE OF THE TRAINING OF THE FINAL USER, WHICH MUST ALSO
BE INFORMED ON THE SAFETY MEASURES TO COMPLY WITH.
THIS INSTRUCTION MANUAL COMES WITH EACH EQUIPMENT.
4.1 CONTROLS
THE CONTROLS AND PILOT LIGHT ARE SET ON THE RIGHT SIDE OF THE BASE WHEN THE
MACHINE IS PLACED IN FRONT OF THE OPERATOR. (Fig.2)
1. BUTTON FOR STARTING AND STOP THE EQUIPMENT
2. KNOB FOR ADJUSTING SLICE THICKNESS
3. LUBRICATOR
4.2 SETTING THE FOOD ON THE SLICER SADDLE
1. SET THE FOOD ON THE SADDLE WHEN THE THICKNESS ADJUSTING KNOBIS SET TO ZERO
AND WITH MOTOR OFF TO AVOID DAMAGING THE EQUIPMENT.
2. SET THE FOOD ON THE SADDLE AND BLOCK IT WITH THE FOOD-PRESS.
3. SET A HAND ON THE FOOD-PRESS AND START THE CUTTING.
4. WHEN THE FOOD IS FULLY SLICED USE THE FRONT PART OF THE FOOD-PRESS TO KEEP
THE FOOD AGAINST THE BLADE.
5. WHEN THE CUTTING IS OVER, PUT OFF THE MOTOR AND STOP THE SLICE THICKNESS ON
ZERO POSITION, THEN REMOVE THE FOOD FROM THE SADDLE. (Fig.3-4)
5) CLEANING AND MAINTENANCE OPERATIONS

GENERALITIES AND PRODUCTS FOR CLEANING

BEFORE CARRYING OUT ANY CLEANING OR MAINTENANCE OPERATIONS, CHECK TO MAKE
SURE THAT THE MAINS SWITCH BE OFF AND THE SUPPLY PLUG DISCONNECTED FROM THE
MAINS.
ACCURATELY CLEAN THE EQUIPMENT EVERY DAY FOR A CORRECT OPERATION AND LIFE OF
THE EQUIPMENT.
DESPITE THE SEVERAL SAFETIES, TAKE GREAT CARE TO AVOID CUTTING RISKS WHEN USING
THE BLADE.
CLEAN THE EQUIPMENT WITH THE USUAL NEUTRAL DETERGENTS WHICH MUST NOT CONTAIN
SODA OR ALCOOL. WHEN CLEANING REMOVED ELEMENTS, DO NOT USE A DISH-WASHER
FOR NOT DAMAGING ANODIZED PARTS.
REMOVAL OF THE BLADE-COVER
1. LOOSEN THE KNOB OPPOSITE TO THE BLADE
2. PUSH THE KNOB TOWARDS THE BLADE AND RELEASE THE BLADE- COVER FROM ITS
HOUSING.
3. REMOVE THE BLADE-COVER FROM THE SLICER AND CLEAN IT WITH A WATER JET. (Fig.5-6)

CLEANING THE BLADE AND RING

CLEANING THE BLADE AND RING IS A DANGEROUS OPERATION, HENCE, TAKE GREAT CARE
TO PREVENT ANY POSSIBILITY OF CUTTING.
FOR THEIR CLEANING NEVER USE A WATER JET, BUT USE A DAMP CLOTH AND DETERGENTS,
THEN RINSE AND DRY WITH A CLOTH.
FOR THE CLEANING, USE NON-TOXIC PRODUCTS WHICH GUARANTEE THE PERFECT HYGIENE.
CLEAN CAREFULLY THE BLADE EDGE AND THE INSIDE OF THE RING.
2. USE A DAMP CLOTH TO CLEAN THE OPENING BETWEEN THE BLADE AND RING.
3. ROTATE MANUALLY THE BLADE AND CLEAN USING THE DAMP CLOTH. (Fig.7-8)
11
PERSONNEL IN
4) USE OF THE EQUIPMENT
CHARGE OF THE INSTALLATION AND ELECTRIC