Human Touch ht 7450 Manual De Uso Y Cuidado página 12

care and maintenance
To keep your product working and looking its best, please follow
these simple care guidelines.
Cleaning:
1. Be sure to disconnect the power cord from the electrical outlet before cleaning.
2. Do not use benzene, thinner or any other solvents on your massage chair.
3. Remove dust on the backrest or armrest with a vacuum.
4. If the backrest or armrests become soiled, wipe with a damp cloth, then a dry cloth.
5. Common upholstery cleaners may be used for tough stains.
6. When cleaning the controller or around the power switch, use a dry cloth only. Never use a damp cloth to clean
the controller or power switch.
Fabric Care:
To maintain your Human Touch product in optimum condition, dust it frequently and/or vacuum it with a soft brush vacuum
®
extension. Faux Suede products can also be brushed with a suede brush. Wipe with a slighty damp cloth as necessary. For
tougher stains on non-leather products, use a mild detergent mixed with water. Leather products should be wiped down
occasionally with a leather furniture cleaning solution.
WARNING:
Be sure to test any cleaning solution on a small, inconspicuous part of the product to ensure that the color does not fade prior
to using the solution on the entire product surface.
Maintenance and Repair:
1. The mechanics of this product are specially designed and constructed to be maintenance free. No periodic lubrication
or servicing is required.
2. Your chair should only be serviced by an authorized service center.
Storage:
1. When not in use for a long period of time, we recommend that the chair be covered, the power cord be coiled and
that the unit be placed in an environment free of dust and moisture.
2. Do not store near heat or open flame. Do not leave this product exposed to direct sunlight for long periods of time.
This may cause fading or damage.
Miscellaneous:
1. Foreign objects should not be inserted between the massage nodes or the unit housing.
2. Care should be taken not to overload the unit.
To replace a fuse:
1. Turn the Power switch to OFF and unplug the chair from the
wall outlet.
2. Turn the fuse holder (located on the power panel) approximately
1/8 turn anti-clockwise. The fuse holder pops out.
3. Replace the fuse with a new fuse of the same value, then reinsert
the fuse holder into the power panel.
4. Turn the fuse holder 1/8 turn clockwise to secure it.
5. Plug the chair back in and turn it on.
22
humantouch.com
Specifications*
Operating voltage: 220-240V~ 50/60Hz
Power consumption: 200 Watts
Chair size (reclined): 172cm H x 70cm W x 74cm H
(67.5"L x 27.5"W x 29"H)
Product weight: 90.72kg
Maximum load weight: 130kg (285 Lbs.)
Rear clearance required: 55cm (21.5")
*Specifications are subject to change without prior notice.
Warranty
For warranty information, please contact your distributor.
23